Automatic Filling Machine and Fruit Washing Machine for Fruit Processing Line

The use and operation method of the automatic filling machine: before the automatic filling machine is started, the disinfection level should be checked, the power supply and air pressure are normal; the manual method should be used to check whether each solenoid valve and cylinder are normal; the action is normal; the water pump turns normally; there is no discharge. gas. If abnormal conditions are found, production can only be carried out after troubleshooting.
The automatic filling machine of the fruit processing production line automatically cleans, sterilizes, fills, covers and seals during the production process without manual intervention. However, the operator must closely observe the status of each part, find problems, and automatically switch to manual in time to prevent accidents. When the chain position is wrong, push out the spindle manually, then push the chain to the normal position. Disinfectant should be replenished in time during work to prevent the pump from idling in an anhydrous state and burning out the seal. After the automatic filling machine is completed, the residual liquid in the pipeline should be discharged, the air circuit and water source should be cut off, and the power supply should be turned off.
Daily maintenance method of automatic filling machine for fruit processing production line: We must regularly check some parts. The inspection parts are: worm gear, bolts on the lubricating block, worm, bearings and other moving parts, to see if these parts are flexible in rotation, if any defects are found, they should be repaired in time. The automatic filling machine should be used in a dry and clean room, and try not to use it in places where the atmosphere contains acids and other gases that are corrosive to the body.
The automatic filling machine of the fruit processing production line should be cleaned and installed correctly after use to prepare for the next use. If the rollers move back and forth during work, adjust the screws on the stroke of the front bearing to the proper position. If the gear shaft moves, please adjust the screw behind the bearing frame to the proper position, adjust the bearing clearance, and the pulley is properly tight, too tight or too loose will damage the machine. If the packaging machine equipment is not used for a long time, the whole body of the automatic filling machine must be cleaned, and the exposed surface of the machine parts should be coated with anti-rust oil and covered with a cloth. If the device is not used for a long time, all parts must be checked for normality before use.
Daily maintenance of fruit washing machine in fruit processing line: chain adjustment. The adjustment stops after the motor stops. Use your fingers to press the chain between the two sprockets. Tightening is usually between 4 and 9mm, which is standard. Once the standard value is exceeded, the idler should be adjusted to normal tightness. CVT changes. The motor should be stopped before checking and refilling the CVT oil. When the fire is smoking, it is strictly forbidden to remove the oil inspection plug. Appropriate amount of oil flows out, and needs to be replenished when insufficient.
Belt adjustment of fruit washing machine in fruit processing production line. After the motor stops, use your fingers (middle and index fingers) to press the standard value of 7-12mm between the two pulleys of the belt. When it exceeds the standard value, adjust the idle speed to the normal tightness. Hosting is not used for a long time. When we want to stop long-term storage not in use, stop washing and wiping all local soil and other objects, clean all rotating parts, straps and chains attached to debris, every rotating part and friction activity, fill with grease to prevent rust.
The above are some knowledge points about the automatic filling machine and fruit washing machine of the fruit processing production line. It can be seen that the production division of the fruit processing production line is very rigorous and meticulous. For our fruit processing production line, we It will further improve the awareness of quality and safety, and put the requirements related to food safety and health in an important position.